Enable IP and default gateway on Network Switches
Network Switches require IP addresses to enable remote management and configuration. If the IP address is not configured the IP address, the network administrator can’t easily connect to the device for remote management. The remote management software and protocols, for example, Telnet, TeraTerm, SSH, HTTP, or HTTPS also required an IP address for connectivity.
A network switches does not have a dedicated interface to which the IP address can be assigned. Therefore, the IP address is assigned and configured on a virtual interface called a switched virtual interface also known as SVI. We can also assign a default gateway to network switches. The default gateway should be the IP address of the router interface. For example, the default gateway for switch0 is 192.168.0.1 and the 192.168.1.1 for swithc1.
Generally, first usable IP address or last usable IP addresses are reserved as the default gateway address. In this diagram first IP address of both subnets already used as router interface address, so I am going to configure last usable IP address of both subnets (192.168.0.254 and 192.168.1.254) as the default gateway on both switches.
Switch#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#interface Vlan1
Switch(config-if)#ip address 192.168.0.254 255.255.255.0
Switch(config-if)#no shutdown
Switch(config-if)#exit
Switch(config)#ip default-gateway 192.168.0.1
Switch(config)#
Do this for switch1 also and assign IP address 192.168.1.254.
